微信扫码
在线客服
用户中心
热线电话
返回顶部

    理士蓄电池DJM12200S UPS输出保护功能:

    分享到:
    点击次数:401 更新时间:2022年05月12日11:10:56 打印此页 关闭

    理士蓄电池DJM12200S UPS输出保护功能:

    (1)输出短路保护:输出负载短略时,UPS应立即自动关闭输出,同时发出声光告警。

    (2)输出过载保护;输出负载超过UPS额定负载时,应发出声光告警;超出过载能力时,应转旁路供电。
    (3)过湿度保护:UPS机内运行湿度过高时,发出声光告警并自动转为旁路供电。(4电池电压低保护:当UPS在电池逆变工作方式时,电池电压降至保护点时发出声光告警,停止供电。
    (5)输出过、欠压保护:UPS输出电压超过设定值时,发出声光告警并转为旁路供

    (6)抗雷击浪涌能力:UPS应具有防雷装置,能承受模拟雷击电压波形10/700us,幅值为5kV的冲击5次,模拟雷击电流波形8/20us,幅值为20kA的冲击5次,每次冲击间隔为1min,设备仍能正常工作,防雷装置具有保护功能。残压不高于1500V。

    150B.jpg

    (1) Output short-circuit protection: When the output load is short, the UPS automatically shuts down the output and generates an audible and visual alarm.

    (2) Output overload protection; When the output load exceeds the rated UPS load, an audible and visual alarm is generated. When the overload capacity is exceeded, the power supply should be transferred to bypass mode.

    (3) Over-humidity protection: When the humidity inside the UPS is too high, the UPS generates an audible and visual alarm and automatically switches to bypass power supply. (4 Battery low voltage protection: When the UPS works in inverter mode, an audible and visual alarm is generated when the battery voltage reaches the protection point, and the power supply stops.

    (5) Output overvoltage and undervoltage protection: When the UPS output voltage exceeds the preset value, an audible and visual alarm is generated and the UPS switches to bypass mode

    (6) Lightning surge resistance: THE UPS should have lightning protection device, which can withstand the simulated lightning strike voltage waveform 10/700us, the amplitude of 5kV impact 5 times, simulated lightning current waveform 8/20us, the amplitude of 20kA impact 5 times, each impact interval is 1min, the equipment can still work normally, the lightning protection device has the protection function. Residual pressure is not higher than 1500V.

     


    上一条:江苏理士电池DJ200 2V200Ah直流屏电源抢修 下一条:理士蓄电池DJM1265S具有很强的耐压过充能力和过充寿命